Skip to content
VATTI Malaysia
Menu
Triple Intake Series T Type Cooker Hood V937, front view

Triple Intake Series T Type Cooker Hood V937

V937

A T-type hood with three intake cavities instead of one, a wide one between two narrow ones, so the low-pressure zone covers the whole hob rather than the middle of it. 2,500 m³/h against 1,050 Pa at 50 dB, and it reads the duct it is fitted to and sets its pressure to match. The main oil filter comes out in one piece for the sink. 896mm wide, hung 650 to 700mm over the hob.

2 year warranty10 years on the motor, 2+3 on the auto-clean partsRegister it

Airflow
2,500m³/h
Pressure
1,050Pa
Noise
50dB
Oil capture
85%

Specifications

  • Pro Nano coating
  • Curve corner for safety
  • BLDC motor
  • Water-proof motor
  • Steam & hot wash auto clean
  • Intelligent auto suction control
  • Hand sensor
  • Three cavity hood
  • Full touch panel
  • Anti rust coating
  • Ducted or recycled

Dimensions and installation

The figures off the V937 drawing, in full. Whether it fits is the question that ends a shortlist, so it is answered here rather than four megabytes into a PDF.

The appliance

Width
896 mm
Depth512 mm with the back feet
500 mm
Heightchimney closed
908 mm
Chimneysecond chimney section, 396 mm
400 mm wide
Chimney adjustment
0 to 320 mm
Canopy depth325 mm with the back feet
322 mm

The space it goes in

Clearance above the hoba T-type hangs high; the canopy is what catches the smoke
650 to 700 mm
Bottom of hood from the floorover an 850 mm cabinet
1,500 to 1,550 mm
Cabinet opening
910 mm
Ducting hole from the floor7 inch, back to back or side way
2,370 to 2,420 mm
Hood outlet
190 mm diameter
Ventilation hose
180 mm inside, 185 mm outside
Telescopic pipe to the ceiling
120 mm minimum

Check it against your kitchen

The drawing is quoted from the floor of a kitchen with an 850mm counter. Put your own numbers in and it re-reads itself.

mm
mm
650 to 700 mm1,500 to 1,550 mm2,370 to 2,420 mm910 mm
Bottom of the hood, off the floor
1,500 to 1,550 mm
Ducting hole, off the floor
2,370 to 2,420 mm

Fits. The V937 is 896 mm wide and wants 910 mm of clear opening.

A guide, not a survey. Your dealer measures the run before quoting.

Dimensions (PDF)

Detail

The V937 lit from below, its three intakes showing
The three intake cavities of the V937 seen from below

Three cavities, in a 1:5:1

Most hoods pull through one cavity. This one is divided into three, a wide one between two narrow ones, which spreads the negative pressure zone across the whole hob instead of concentrating it under the middle of the canopy.

The V937 control chip and panel

It matches the duct it is fitted to

The hood measures the resistance of the run it is pushing into and sets its pressure against it: low pressure where the duct is short, which is quieter and cheaper to run, and full pressure where the duct fights back.

The V937 impeller being steam cleaned

Steamed auto-clean, in four steps

Frequency-conversion auto-clean with steam rather than a cold rinse:

  • Take the oil cup out from under the hood
  • Fill the cleaning water cup and put it in the cup's place
  • Hold the auto-clean key for one second to start
  • Pour the dirty water out and put the oil cup back
The V937 oil filter separated from the siphon cavity, each part labelled

The whole filter comes out

The main oil filter disassembles completely, so it is cleaned in the sink rather than wiped at arm's length above a hob. The labels on the diagram are the parts: an airfoil suspended siphon cavity above an oval oil filter.

The V937 motor housing on a plinth

Quiet in three places at once

50 dB, which VATTI reaches by treating noise where it is made rather than muffling it afterwards.

  • A frequency-conversion chip and ball bearings, for mechanical noise
  • A patented V-shaped housing, for aerodynamic noise
  • Porous sound-absorbing material, for what is left
  • The V937 light over a hob

    LED soft light

    Thrown down onto the hob rather than into your eyes.

  • The V937 filter being washed under a tap

    Detachable oil filter

    Out in one piece, into the sink, back in.

  • A hand held under the V937 panel

    Hand gesture control

    Started and stopped without touching the glass.

The V937 from the side, chimney and canopy

In action

A minute with the V937 running: the three intake cavities, the panel, and the canopy over a working hob.1 October 2023 · 1m 4s
Two minutes on cleaning: the oil filter coming out in one piece, and the steamed auto-clean cycle from the panel.30 March 2024 · 2m 4s

How it compares

The V937 against the models it is usually shortlisted with. Press a column to sort by it.

Every model, with its measured airflow, pressure, noise, oil capture. Column headers sort the table.
Model
V937Triple Intake Series T Type Cooker Hood V9372,5001,0505085
V931Artemis Series Cooker Hood V9311,8604205485
V938VATTI Hidden Series Range Hood V9383,6501,6004892
V960VATTI Stellar Series Cooker Hood V9603,690 (best in range)1,700 (best in range)4892

Questions about the V937

What size is the VATTI V937?
896 mm wide, 500 mm deep, or 512 mm counting the back feet, and 908 mm tall with the chimney closed. The chimney is 400 mm wide and adjusts through 320 mm. Built into a cabinet it needs a 910 mm opening.
How high should the V937 be installed above the hob?
650 to 700 mm from the hob surface to the bottom of the hood, which puts the bottom 1,500 to 1,550 mm off the floor over a standard 850 mm cabinet. A T-type hangs higher than a slant hood on purpose: the canopy is deep, and the cook has to be able to stand under it.
What ducting does the V937 need?
A 7 inch run. The outlet is 190 mm across and the hose is 180 mm inside, 185 mm outside. The wall or ceiling hole sits 2,370 to 2,420 mm off the floor, back to back or to the side, with at least 120 mm from the telescopic pipe to the ceiling.
What does the triple intake actually do?
It spreads the suction. One cavity pulls hardest directly under itself; three cavities in a 1:5:1 arrangement hold a low-pressure zone across the full width of the hob, so a pan on the front left burner is under the hood as much as a pot in the middle is.
Is 2,500 m³/h enough for a condominium kitchen?
With 1,050 Pa of static pressure behind it, yes for most. Pressure is what matters once the duct is long or has bends, which is the usual high-floor case. If yours is a long shared run, the V929 pushes 1,300 Pa and the V938 1,600 Pa.
How is the V937 cleaned?
A steamed auto-clean cycle you start from the panel, and a main oil filter that disassembles completely so it can be washed in the sink rather than wiped in place. Oil filtration is 85%, and the surface carries a pro nano coating.
What warranty does the V937 carry?
Two years on the hood and ten years on the motor, for the original buyer, bought from an authorised dealer. Register it at VATTI eWarranty at the time of purchase: a claim needs the registration to be complete.
How much is the V937 and where can I buy it?
VATTI Malaysia does not sell online. The V937 goes through authorised dealers, who quote their own installed price against the ducting your kitchen needs. Find the nearest one in the dealer directory, or send us your kitchen layout and we will point you at the one that stocks it.

Where to buy the V937

VATTI Malaysia does not sell online. The V937 is sold and installed by authorised dealers, who quote their own installed price against the ducting your kitchen needs. Tell us your layout and we will point you to the nearest one that stocks it. Replies within 48 hours.

76 authorised dealers

Backed by a service team Malaysians rate 5 stars

Excellent

Rated 5 out of 5

Based on 67 reviews

  • Rez Mumy

    5 months ago

    5 out of 5

    Both technician efficiently explain the suction issue.
  • Sky Ng

    5 months ago

    5 out of 5

    Good Service, and Fast Settle
  • Michael Chong

    5 months ago

    5 out of 5

    Good after sales service
  • roszaida othman

    5 months ago

    5 out of 5

    hood problem…technician datang tukar board terus ok…technician berpengalaman service pantas dan friendly…puas hati…
  • Puvaneswary Thirunganam

    5 months ago

    5 out of 5

    Had problem with cleaning the hood. Jack & Kishore had solved it. Very fast action
  • Emily Mong

    5 months ago

    5 out of 5

    Good Service
  • Carol Quek

    6 months ago

    5 out of 5

    Good after sales service. Both technicians Mr Jack and sales personal are responsible and fast response.
  • Farouq Mohamed

    6 months ago

    5 out of 5

    Good response from technician regarding my device issue.good service
Still deciding

3 Types of Range Hoods for Your Kitchen - A Buying Guide (2026)

5 minute read
Let us help you now